Below is a list of supported and non-supported features of the printer. Set Device Type to Custom and click Settings. Sometimes you may have to reboot your printer if it does not print. We do not have tools for communicating bi-directionally in Linux and Mac environments. In this case, all packets meant for the Gateway will be silently discarded. Sometimes it is necessary to run the printer on an indirectly connected network.

Uploader: Mazurr
Date Added: 9 October 2016
File Size: 45.46 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 97026
Price: Free* [*Free Regsitration Required]

Enter the name you wish to call the printer in the Printer Name field ex. Is the printer timing out during the retransmission of a packet or in an idle state? The Lemur-M will always have a burster and a 2.


For other interface options, install the printer as you would any other printer. If possible, hook up an HP Jetdirect Print Server to the printer requires a parallel port bocw see if the problem still exists. When I capture with Ethereal, why can’t I see any TCP packets other than packets to and from my machine, even though another analyzer on the network sees those packets?

It must send its responses through a gateway in order to reach the destination host. Individual tickets are printed in one to two seconds, but I occasionally have delays of up to ten seconds between tickets. Windows supports the following methods of defining page cgl This command only needs to bocx sent once as it is permanently stored in the printer’s memory.


High resolution graphics and a variety of industry standard bar codes can be easily printed. Set Device Type to Custom and click Settings. Decide fgp you want to share the printer – if so, give it a ‘share’ name ex. Select Boca and choose the appropriate driver that matches your printer configuration They can also be set through the control panel and Web Menus. Sharing the printer is your choice. This might be because the interface on which you’re capturing is plugged into an Ethernet or Token Ring switch; on a switched network, unicast traffic between two ports will not necessarily appear on other ports – only broadcast and multicast traffic will be sent to all ports.

Ethernet Diagnostic Modes should only be used after consulting with Boca Systems. We strongly discourage the use of PCL4 drivers for new Windows-based applications.

Make sure Port Number is set to Select No or Yes for Do you want to print a test bocx Try playing with the following commands to see if it improves performance. The Subnet Mask is used by the printer to determine if the destination is on a connected network direct route.

If you see the printer name in the Printers folder, Right click to delete it. You must have the Boca printer drivers installed on your computer. The printer driver interprets the data from the application and writes to the port parallel, serial, USB or Ethernet. Try to limit the number of jobs opened and closed. General A printer driver translates the graphical information displayed in your Windows application into a printer friendly format.


The printer can return status data item 3 either in response to an external status request or as a result of a change in printer status.

Boca Systems – Ticket Printers, Kiosk Printers

In this case, all packets meant for the Gateway will be silently discarded. One client had an issue where his switches would not auto-negotiate correctly with the printer. PCL4 is primarily a legacy configuration for printers purchased before the development of the FGL drivers.

This command returns the IP address of the Default Gateway in the form. Install Ethereal on the same computer that the Boca was initially installed on. Printer Configuration – FGL vs. In order to properly format the data, the user must correctly establish the page size and margins.